진공관프리앰프에 명성을 가지고 있는 오디오리서치사 6H30을 사용하는
신형라인업 프리앰프 입니다.
전작에 비해 스피드감과 고역에 실키함이 많은 개선이 있는 모델입니다.
중역에 순도를 유지하면서 해상력에 극치를 보여주는 프리앰프 입니다.
풀발란스 진공관 프리앰프이고 탑클라스에 있는 레퍼런스3에 쥬니어
모델 입니다.
해상력높은 스피커와 배스트 매칭입니다.
상태극상에 제품이고 공식수입품으로 원박스등 부속품 있습니다.
570만원 입니다.

오디오리서치 파워앰프 D-300.2 입니다.
TR파워앰프로서 진공관파워앰프에 음색에 스피드감을 빠르게 구사해주는
파워앰프입니다. 현대적인 파워앰프로서 300w급 파워앰프 입니다.
발란스 언발란스 입력 가능하고 현지 리테일가 500만원대 하는 제품입니다.
상태 신동품수준이고 옵션 으로 핸들장착 한 모델입니다.
350만원 입니다.

일괄시 네고 해드리고 추가금 받을만한 프리/파워앰프나 기기와 절충 가능 합니다.
031-254-0772 / 010-2300-0772

LS-26 SPEC
Frequency response +0-3dB, 0.2Hz to 160kHz at rated output (Balanced, 200k ohms load)
Distortion (THD) Less than .01% at 2V RMS BAL output.
Noise & hum 1.3uV RMS residual IHF weighted balanced equivalent input noise with volume at 1 (100 dB below 2V RMS output).
Gain Main output : Selectable for each input: 24dB, 18dB, 12dB Balanced output. (18dB, 12dB, 6dB SE output.)
Record output: 0dB (Processor input: 0dB balanced.)
Input impedance 120K ohms Balanced, 60K ohms SE.
Output impedance 700 ohms Balanced, 350 ohms SE Main (2). 20K ohms minimum load and 2000pF maximum capacitance.
Output polarity Non-inverting.
Maximum inputs Low Gain: 48V RMS BAL, 24V RMS SE.
Medium Gain: 24V RMS BAL, 12V RMS SE.
High Gain: 12V RMS BAL, 6V RMS SE.
Rated outputs 2V RMS 1Hz to 100kHz into 200K ohm balanced load (maximum balanced output capability is 15V RMS at less than 0.5% THD at 1kHz)
Power supplies Electronically-regulated low and high voltage supplies. Automatic 50 sec. warm-up/brown-out mute. Line regulation better than .01%.
Tube complement (2) 6H30 dual triode. (Hybrid JFET/tube audio circuit, solid-state power supply).
Power requirements 105-130VAC 60Hz (210-260VAC 50/60Hz) 50 watts maximum.
Other Rotary volume selector (104 steps) and rotary input selector.
Push buttons: Power, Monitor, BAL/SE, Proc, Mute.
Remote buttons: Display, Bal L, Bal R, Hours, Invert, Gain.
Dimensions 19" (48 cm) W x 5.25"(13.4 cm) H (standard rack panel) x 12"(30.5 cm) D. Handles extend 1.50" (3.8 cm) forward of the front panel.
Weight 16.5 lbs. (7.5 kg) Net; 26 lbs. (11.8 kg) Shipping.

D-300.2 SPEC
Power output 300 watts per channel into 8 ohms, 500 watts per channel into 4 ohms, both channels driven, 1% THD. (600 watts into 4 ohms, one channel driven)
Power bandwidth (-3dB points) 5 Hz to 30 kHz into 8 ohms or 4 ohms
Frequency response (-3dB points at 1W) 5 Hz to 120 kHz
Input sensitivity 2V RMS for rated output (28 dB Gain) single-ended or balanced
Input impedance 150K ohms single-ended, 300K ohms balanced differential
Output taps
Output regulation 0.05 dB 8 ohm load into open circuit
Overall negative feedback
Damping factor 200
Distortion
Slew rate 20 volts/microsecond. (20% maximum duty cycle)
Rise time 2.0 µs
Hum & noise 600 µV RMS (98 dB below rated output IHF A-weighted)
Power supply energy storage 136,000 µF total
Power requirements 100-125VAC 60Hz (200-250VAC 50Hz) 800 watts at rated output (300WPC 8 ohms), 1200 watts at 500WPC 4 ohms, 1200 watts maximum, 50 watts idle.
Other Output polarity: Non-inverting from single-ended inputs. Balanced pin 2+ (IEC-268).
Output current: 25 amps peak at protective shutdown.
Balanced and single ended inputs
12 V trigger
Detachable 14 gauge A.C. power cord

Dimensions 19" (48 cm) W (standard rack panel) x 7" (17.8 cm) H x 14.25" (36.2 cm) D (front panel back). Optional handles extend 1.5" (3.8 cm) forward of the .25" thick front panel. Output connectors extend 0.9" behind rear panel.
Weight 39.2 lbs. (17.8 kg) Net; 51.2 lbs. (23.3 kg) Shipping.