JAPAN ANALYTICAL INDUSTRY CO., LTD. CRYOGENIC SAMPLE CRUSHER JFC-300 냉동분쇄기 

상태양호

 

The JFC series of cryogenic sample crushers consist of a cell, a tungsten carbide steel ball. The sample and the steel ball are placed inside the cell which is attached to a crush rod and the rod is attached to the main unit. The cell is immersed in liquid nitrogen to cool the sample and the steel ball. Then the crush rod is set in up and down reciprocating motion. The steel ball inside the cell pulverizes the sample into a fine powder.

 

Feature

*All kind of polymers, such as plastic and rubber, can be crushed after cooled in liquid nitrogen.

*Perfect for sample preparation of polymer additive analysis, outgas analysis from polymers, natural products and biological sample analysis.

*Economical operation with low consumption of LN2

*The sample cell is made of stainless steel (standard) or titanium (option).

*High resolution NMR spectrum can be obtained after pulverization.

*When vulcanized rubber is crushed with KBr, IR measurement can easily be made from the KBr disk.

　　　

Polyacetal, hard PVC, soft PVC, silicone rubber, printed circuit board, vulcanized IIR, cellulose, tire, etc.

Maximum of 3 g sample in the JFC-300 cell can be crushed.

For HDPE 1.5 g is the maximum allowed in the JFC-300 cell.

 

Specifications

 

Crush method: Vertical reciprocating method

Number of cycles: At 50 Hz,

          About 1,250 cycles/minute

          At 60 Hz, About 1,450 cycles/minute

 

Cell: Internal volume 12 ml

Dewar vessel: Internal volume 1,000 ml

Timer: Setting of pre-cooling time and crushing time

Power supply: 100 to 115 VAC ± 10%, 2 A (standard)